- TCP
Description:
-It stands for Transmission Control Protocol
-It will establish connection first
-The sender and receiver must agree to have connection with each other
-It will connect when there's connection and it will be error if there's no connection
Diagram:
- IP
Description:
-It stands for Internet Protocol
-To transfer packet to correct destination(makesure it deliver to the correct person)
Diagram:
- UDP
Description:
-It stands for User Datagram Protocol
-It send information directly without establish connection
Diagram:
- AppleTalk
Description:
-Appletalk only able for Apple/Mac user only
-Phase 1 use for smaller network
-Phase 2 use for larger network
Diagram:
- 802.2
Description:
-It stands for IEEE 802.2 Logical Link Control
-IEEE stands for Institute of Electrical and Electronics Engineers
-It runs on data link layer of OSI model
-It acts as translator for data link layer so whatever message that pass to the layer can be understood
Diagram:
- 802.3
Description:
-The another name is Ethernet
-It use for devices by local area network product that define CSMA/CD
-The higher data rate,more expensive
Diagram:
- FDDI
Description:
-It stands for Fiber Distributed Interface
-It only use two ring
-It goes opposite direction of each other
-First ring(primary) and second ring is for backup(secondary)
Diagram:
- 802.5
Description:
-The token will pass around the ring
-The token control the transmission of data on the network
-When you want to send a message,you need the token.If it's being use,you to wait until the token is available
-The token control the transmission of data on the network
-When you want to send a message,you need the token.If it's being use,you to wait until the token is available
Diagram:
References:
No comments:
Post a Comment